NORMA AUDIO ELECTRONIC
T. +39 (0) 372.493113 | E-Mail: info@normaudio.com

– 5 digital inputs, USB, 2 x SPDIF RCA, SPDIF OPTICAL, AES-EBU. USB input and SPDIF full bandwidth, up to 32 Bit / 384 KHz & DSD 512.
– Possibility to customize for each digital input all parameters, including clock source, phase.
– Possibility to use as the master D/A clock source the local oscillator or the clock form input signal.
– Two separate local clock oscillator for the two values , 22MHz / 24 MHz (44.1 / 48KHz).
– Local Oscillator high stability, low Jitter and low phase noise.
– Two PCM 24 Bit Digital to Analogue converter.
– Proprietary I-V architecture conversion.
– Analogue output stage based with full discrete devices amplifier.
– Extreme low noise, high resolution and high speed.
– Wide band ( >2 MHz ) schematic topology.
– RCA and Balanced output connection.
– Separate power supply for Digital and Analogue Output stage.
– High filtering capacity with numerous low impedance capacitors.
– 15 Powers supply regulators.
– Toroidal transformer specially designed for audio applications.
Connections Digital Inputs
IN1: USB, 2.0 High Speed
IN2: SPDIF RCA, 75Ohms
Connections Digital Inputs
IN3: AES/EBU XLR, 110Ohms
IN4: TOSLINK OPTICAL, 96 KHz, (384.0 KHz may be achieved, but not guaranteed)
Connections Digital Inputs
IN5 : SPDIF RCA, 75Ohms (IN5 can be set as SPDIF Output by Signal Processor)
Sampling Frequencies
PCM: 44.1KHz, 88.2KHz, 176.4KHz, 352.8 KHz, 48.0KHz, 96.0KHz, 192.0KHz, 384.0 KHz
DSD: x64, x128, x256, x512
Based on
CT 7302
Clock performances
+/- 2ppm typ. at 25°, +/- 10ppm at 60°
Digital Filter
Fixed Slow Mode, based on TI DF1706
Connections Outputs
Line RCA output, XLR Balanced
Outputs Voltage
3.0 V RMS (+10 dBV) RCA (at 0 dB), 6.0 V RMS (+16 dBV) XLR(at 0 dB)
Output Impedance
200 ohm
Analogue Output Filter
0,0 to 180 kHz +/- 3 dB
Analogue Stage Frequency Response
0,0 to 2MHz +/- 3 dB
Configuration
Solid state
Oversampling Filter
Fixed Slow Mode
D/A Converter
PCM 1704 Multibit 24 Bit D/A converter
I/V Conversion
I/V Conversion by proprietary topology with discrete component
Output Stage
Proprietary topology with discrete component, high linearity & low noise
Supply
230 V AC / 50 Hz, (100V AC or 115 VAC / 50-60Hz in some country)
Dimensions (HxWxD)
126 x 215 x 350 mm
Weight
5 Kg
Note
DAC Source with full remote control on PRE Version